Ultrasonic level switch online shopping from drurylandetheatre.com? The Displacer level controller changes the magnetic float to a float. Displacer level transmitter uses tiny metal film strain sensing technology to measure liquid level, interface or density. Such as Fisher DLC3010 Digital Level Controller. The hydrostatic level controller works by using the measuring principle of hydrostatic pressure. Generally, a silicon pressure sensor is used to convert the measured pressure into an electrical signal. Then it is amplified by the amplifier circuit and compensated by the compensation circuit. Finally, it is output in 4-20ma or 0-10ma current mode. Sino-Inst offers over 10 Ultrasonic Liquid Level Controllers for level measurement. About 50% of these are fuel level meters, 40% is the tank level sensor.
The advantages of ultrasonic liquid level gauge are very outstanding. It is mainly reflected in the following aspects : The structure is simple. The reading is convenient. It is very easy to install and maintain. Of course, the ultrasonic liquid level gauge also has its own limitations and insurmountable defects. Specifically, it is mainly manifested in: There is a blind spot in the ultrasonic liquid level measurement. The dead zone is the area where the meter cannot measure. During the transmission of ultrasonic pulses, a small area near the ultrasonic transducer usually cannot receive sound waves. The blind zone where sound waves cannot be received is related to the measurement distance of ultrasonic waves. Generally speaking, the smaller the measurement distance, the smaller the blind zone. The larger the measurement distance, the larger the blind zone.
In the measurement, the ultrasonic pulse is emitted by the sensor (transducer), and the sound wave is reflected by the liquid surface and then received by the same sensor or ultrasonic receiver. Through piezoelectric crystal or magnetostrictive device into electrical signals. The distance between the sensor and the measured liquid surface is calculated by the time between the transmission and reception of sound waves. Find more details on Ultrasonic level switch.
HS-2000 External Mounted Ultrasonic Tank Level Sensor- (referred to as “external level gauge”). It adopts advanced signal processing technology and high-speed signal processing chip. It breaks through the influence of container wall thickness. Realizes the height of the liquid level in the closed container True non-contact measurement. The ultrasonic liquid level sensor (probe) is installed directly under the outer wall (bottom) of the container under test. Non-contact measurement function , Ultrasonic sensor probe is external. No need to open a hole in the container to be tested.
What does a level switch do? The function of the liquid level switch is to control the liquid level. For example, the water pump fills the pool with water, and the level switch can make the water in the water tank neither overflow nor empty, and there is always water. “ Can ultrasonic sensor detect water level? The ultrasonic sensor can of course measure the water level. When the ultrasonic level gauge is working, the high-frequency pulse sound wave is emitted by the transducer (probe), and is reflected on the surface of the measured object (water surface). The reflected echo is received by the same transducer (probe) and converted into an electrical signal . The time between pulse sending and receiving (the movement time of the sound wave) is proportional to the distance from the transducer to the surface of the object. Find extra details on this website.