Pcb manufacturer and supplier 2022? Peelable mask are applied by screen-printing, act as in-process protection and are removed after processing at the assembler. Because the fabricator can apply the mask in any design, they can create one fluid piece which will allow the customer to peel the entire design off in one pull. Peelable mask provides protection in soldering processes like wave soldering, reflow soldering or hot air solder leveling(HASL). Rebiable, time-saving and cost-saving in their application, they have long surpassed manual masking with heat-resistant tapes. Read additional details on pcb manufacturer China.
Advantage of MCPCB: Some LEDs dissipate between 2-5W of heat and failures occur when the heat from a LED is not properly removed; a LED’s light output is reduced as well as degradation when the heat remains stagnant in the LED package. The purpose of a MCPCB is to efficiently remove the heat from all topical IC’s (not just LEDs). The aluminum base and thermally conductive dielectric layer act as bridges between the IC’s and heat sink. One single heat sink is mounted directly to the aluminum base eliminating the need for multiple heat sinks on top of the surface mounted components.
Our automated X-Ray inspection systems are able to monitor a variety of aspects of a printed circuit board in assembly production. The inspection is done after the soldering process to monitor defects in soldering quality. Our equipment is able to “see” solder joints that are under packages such as BGA, CSP and FLIP chips where the solder joints are hidden. This allows us to verify that the assembly is done correctly. The defects and other information detected by the inspection system can be quickly analyzed and the process altered to reduce the defects and improve the quality of the final products. In this way not only are actual faults detectd, but the process can be altered to reduce the fault levels on the boards coming through. Use of this equipment allows us to ensure that the highest standards are maintained in our assembly.
There are total 420 highly trained full-time employees with land area 30000 square meters and building area 18000 square meters in our PCB plant, we mainly focus on high-mix, low to medium volume pcb fabrication as well as quick turn pcb prototype to meet 24 hours delivery for double sided PCB, 48 hours for 4 to 6 layers and 72 hours for 8 or more high multilayer PCB at the fastest. The production capacity is 25000 square meters and more than 3000 varieties per month, the printed circuit boards we manufactured are widely used for different electronics industries, such as telecommunication, consumer electronics, computer, medical, automotives, military and so on, more than 60% of our PCB board are exported to Europe, North America and other Asian countries. Find additional info on https://www.atechpcb.com/.
In order to provide one-stop-services to customers, we can also provide FPC and Rigid-flex PCB Assembly service (also named SMT: Surface Mounting Technology). We can purchase all components from abroad or domestic market, and provide full products to you with short lead time. High Density Interconnects (HDI) board are defined as a board (PCB) with a higher wiring density per unit area than conventional printed circuit boards (PCB). They have finer lines and spaces (<100 µm), smaller vias (<150 µm) and capture pads (300, and higher connection pad density (>20 pads/cm2) than employed in conventional PCB technology. HDI board is used to reduce size and weight, as well as to enhance electrical performance.